|
|
| ASCO
7000 SERIES CLOSED TRANSITION AUTOMATIC TRANSFER SWITCH
|
ASCO Automatic Closed-Transition Transfer Switches feature main
contacts that overlap, permitting the transfer of electrical
loads without power interruption. The switch transfers in a
make-before-break mode if both sources are within acceptable
parameters. Control logic continuously monitors source
conditions and automatically determines whether the load
transfer should be open (conventional non-overlap mode) or
closed transition. Available 150 through 4000 amperes.
Closed-Transition Transfer within 5 electrical degrees is
achieved passively, without control of the engine generator set.
Therefore, no additional control wire runs are required between
the ATS and engine generator set governor. Plus, protective
relaying may not be required under normal operation since the
contact overlap time is less than 100 milliseconds (consult your
local utility on protective relay requirements).
Failure to synchronize indication and extended parallel time
protection is built-in to all 7000 Series closed transition
controls to prevent abnormal operation
Contact Nikki
or David for
information and pricing
Toll Free
888.861.8984
Ph:
605.341.6160
Fax:
605.341.9791
nikki@genpropower.com
connieS@genpropower.com
Taxes collected for South Dakota, Wyoming, and Nebraska
|
(Download
Brochure) |
|
|
• ASCO PARTS • ASCO 165 SERIES • ASCO 300 SERIES • ASCO 7000 BYPASS ISOLATION • ASCO 7000 SERIES • ASCO 7000 CLOSED TRANSITION • ASCO 7000 DELAYED TRANSITION • ASCO 7000 Series • ZENITH ZBTS BYPASS • ZBTSCT Closed Transition • ZBTSD ZENITH • ZENITH ZTS SWITCH • ZTSCT ZENITH • ZENITH ZTG SWITCH • ZENITH ZTGD • ZTGSE ZENITH • ZTSD ZENITH • ZENITH ZTX SERIES •
|
GenPro
Power
Services LLC
2121 Rand Road, PO Box 1116, Rapid City, SD
57709-1116
Ph: 605.341.6160 Fax:
605.341.9791
www.genpropower.com
© 1997-2011 GenPro Power
Services - All Rights Reserved
|
|
|
|
